POWER LEVELS & SNR: TECHNICAL PRIMER (Updated October 2016) PART A - APPLICABLE DOCSIS STANDARDS INTRODUCTION There are no precise numbers for power levels although you can be sure that the numbers offered as optimal here will not be the c...
Hi how do I order the Wi-Fi pods as can’t get the connect app to work?
UNDERSTANDING KEY ASPECTS OF WiFi WiFi is a somewhat notorious, though essential commodity. In many cases, when its behaviour does not meet the user’s perception of the claims made by the ISP (e.g. Virgin Media), the blame is quickly heaped on the IS...
Seeing so many posts about Good, Bad & ugly Wifi, I thought I would post some suggestions for people out there. There are definitely good, midrange & poor routers with quite variable performance wifi. Never expect a mass market product to be the b...
hi we have had thousansds of post RS errors and the tv have been having serious tv glitching. Upstream bonded channelsChannel Frequency (Hz) Power (dBmV) Symbol Rate (ksps) Modulation Channel ID 049600000465120QAM 64114310000045.85120QAM 642236600000...
I'm getting very frequent hitches in my connection across all devices. I never used to have any issues but in the past few months it's getting worse and worse.I'm using a Hub 3 (i think) in modem mode connected to a wireless router. I do have my main...
I have had intermittent connectivity issues for over 2 weeks and constant red light on hub 3. I'm sick of being told to wait 24 hours, then 48 hours, then 24 hours whilst my connectivity is monitored. Now been told all is fine but still constant red...
Hi, Going to install TP-Link Deco X20 AX1800 system tomorrow. I have a hub 4. Do I put it into modem mode or not?. Anything else to consider?thanks
Hi, I'm a new customer, and on the installers advice I purchased a TP Link Deco P9 system to boost the signal round the house. Ive managed to get everything connected and working, apart from the dongle on my Luxpower inverter, which I use to monitor ...
Hi I’m posting for the 3rd time. I keep getting told I’m posting to moderators but no instructions where to post. Hopefully I’m on the right forum now. I have installed a ring doorbell system but the WiFi signal is very poor so I was wondering can I ...
I have solid red power light for few weeks, have pin reset and rebooted a few times. Light still red, internet working, is this a problem?
For the last 3 days signal strength has been dropping low and off After pressing check my system it yet again says there are problems in this area AGAIN Only a couple of weeks since last problem that kept going on 2 weeks
Everything is in check but the BQM and latency spikes continue. Why is this service for garbage with latency spikes - is there a fix? I need an engineer out to investigate this and not just change the hub and call it a day.
