Hub3 in router mode - password?

[LittleGreyCat]

I am having problems with my Hub3 in Modem Mode.

It is many years since I tried to log into 192.168.100.1.
With a PC connected directly to Port 1 of the hub I can connect to the Internet and also connect to 192.168.100.1
However I can't remember the password.

A quick search suggests that the default is "admin".
This doesn't work.
There is also a numerical settings password on the label on the base.
This doesn't work.
I have tried a couple of old favourites (I know) and these don't work either.
Is there another password on the base of the hub?
I have a set of WiFi passwords but I am running in modem mode.

Do I have to push a pin into the reset hole and start all over again?

If so, will the default password be "admin" or "bunch of numbers"?

[legacy1]

reset and the password listed on the hub

[LittleGreyCat]

To be clear, is this the list of numbers on the base of the hub?

Or am I expected to configure it via WiFi?

[legacy1]

everything you need to login to the hub after reset should be on the hub sticker/label if you can not read the info then you need a new hub

[Tudor]

If you are running in modem mode why do you need to get into the hubs settings, there is nothing there that you can do except go back to router mode. If you need to look at the stats it’s easy, you do not have to logon at all. I run in modem mode and have only ever gone into the setting on the hub once in all the time I have had it.