User already logged in (when not) on hub

[wiry]

Recently, when I want to configure my hub 3.0 for port forwarding etc, I get this when I try to log in. No one is logged in, I even made sure to log out of my last session, but it still does this:
"Please Note!
Someone else is currently logged into the settings page. Only one session at a time is allowed. Please try again later."

I've had to reboot my hub 3.0 with the pin button to fix this, only for it to come back when I try to log in the second time, unplugging the hub 3.0 from power doesn't make a difference (I had it disconnected for 10/15 minutes and it still didn't work afterwards).

[Apples]

It is very slow to load most pages, agreed.

[Anonymous]

Any reason behind the Huawei phone I need to be made aware of or are you scaremongering?

[jpeg1]

No problem with the Huawei phone, I did put in a smiley. 🙂 

[Adduxi]

A quick search on these Forums would reveal this is a bug and quite common. The app and/or Hub is faulty somewhere, and in a lot of cases it takes a reset to clear this mesage.  As Mike as previously stated - don't use the app .....

[moopcat]

Makes no difference if you are using an app or the web gui as I have never used the app. 

Now getting this often. Sure a power cycle restores it but come on, this should be sorted by now. 

[lens_]

Yup, suffering with the exact same issue needs to be addressed 

[jem101]

When using the web GUI, are you pressing the log off button at the top when done to properly close the session and not just closing the browser window?

[wiry]

Last time I checked, it didn't make a difference

[Ang611s]

I’ve got this same issue. Factory reset doesn’t help 

[Z92]

Last time I had this I left it a few hours and it cleared itself. Most of the router stuff is disabled though to be honest! Have my own WiFi dhcp and dns.