cancel
Showing results for 
Search instead for 
Did you mean: 

Ports will not open via UPNP or otherwise

Jamesp1989
Joining in

We have a hub 3.0 that will not open ports no matter what I do. I have turned on upnp which does nothing. I have turned on both port triggering and port forwarding for port 8080 and I have set the device to have a fixed address via DHCP.

There must be some solution to this other than moving to modem mode and using it as a bridge? 

I'm using just my phone and port checking websites to verify the port is open so windows firewall won't be a factor. 

1 REPLY 1

legacy1
Alessandro Volta

It was aways going to be the case this would happen and blame router mode when modem mode it just works or your the problem.

---------------------------------------------------------------