Forum Discussion
Check the automated service 0800 561 0061 for any known faults in your street.
The single upstream is not correct, the Hub is transmitting at a very high power to be received at the street cabinet, there should be 4 to 6 upstream channels connected all at a lower power level. This looks like a noise (SNR) fault.
Hub Signal Level Checks
Via http://192.168.0.1/ connect to the Hub in Router mode, do not login in, scroll down to "Check router status" Use http://192.168.100.1/ for a Hub in Modem mode
Using the Hub's "Check router status" tabs check the Downstream and Upstream power levels are in spec.
( If already logged in to the Hub menu, the same info is available at : Advanced settings >>> Tools >>> Network status )
Downstream Power Levels of -7 to +7 dBmV are preferred, +10dBmV is the max acceptable, with a SNR of 33dB or higher across all DOCSIS 3.0 channels. Rising error counts across many channels is a current service noise fault.
Upstream Power Levels of 35 to 49 dBmV are preferred, with QAM 64 Modulation mode across all four to six DOCSIS 3.0 channels. Seeing QAM 32/16/QPSK is a current service noise fault. Seeing less than four DOCSIS 3.0 channels is usually a signal level fault.
Hi , thanks for timé taken to reply,
Checked and no area faults reported.
Downstream power levels at 4.9 to 5.4 with an snr of 40.
Upstream only one bonded channel, dbmv is 51, with qam 64.
And bad connection seems to have returned at around 9pm tonight 3/12/23
Related Content
- 25 days ago
- 7 months ago
- 12 months ago