Forum Discussion

billkilv's avatar
billkilv
Up to speed
10 months ago

Router shot?

Hub 4.

Intermittent buffering issues over Wi-Fi

VM Connect unable to connect to the HUB (tried all the re-boots/reinstall).

Cannot access the router set-up (tried different browsers and devices)

100% Packet loss on Broadband Quality Monitor

Real speed seems OK, although sometimes fails to connect the router.

  • jbrennand's avatar
    jbrennand
    Very Insightful Person

    Are any of your neighbours experiencing the same issues?

    Check first for any “known network faults in your location - Look in 2 places

    1) Try the “check service,”Area status webpage (https://www.virginmedia.com/help/service-status)

    2) Then also Try the “free & automated” Service Status number - 0800 561 0061 - which usually gives the most up to date info. and tells you of more local issues and fix estimates, down to street cab/ postcode level.
    The "compensation "timer" can also be started on this number if appropriate.

  • Client62's avatar
    Client62
    Alessandro Volta

    In the recent months many Router mode Hub 4 end up in this state
    ( i.e. admin menu white / blank screen, Connect app not working, VM Pods disconnected )

    The Hub 4 may restart the admin menu & Connect app after
    a 60 second press of RESET, followed by leaving the Hub 4 powered on to revert to the shipping condition.

    The 60s RESET does appear to be a temporary fix that may only last for days before the Hub 4 fails again and ends up back in the same situation.

    A replacement Hub is the likely outcome.


    BQM with a 100% packet loss is often caused by the BQM not pointing at the Public IP of the Hub,
    check the Public IP via : https://whatismyipaddress.com/   ( VPNs & Apple Relay must be OFF to get the correct answer of  ISP = VM + just the IPv4 of the Hub )

  • Sephiroth's avatar
    Sephiroth
    Alessandro Volta

    Client62 is usually right but on this occasion may be putting 2+2 = 5.  

    If the Hub 4 (which I've had for about 4 years) is passing data, then it's not shot.  End of.

    The Connect app is what's shot.  That's well documented and just because Hub 4 users have problems, Client62 has made the association.

    The factory reset never fixes anything that an electrical off/on won't fix.  All it'll do is lose you another 20 minutes of what's left of your life will it calls down the latest firmware.

    Sorry Client62.

     

  • Client62's avatar
    Client62
    Alessandro Volta

    We have seen dozens of instances of Router mode Hub 4 in the same state.
    VM Mods have acknowledged this as an issue under investigation.

    • Sephiroth's avatar
      Sephiroth
      Alessandro Volta

      Client62 wrote:

      We have seen dozens of instances of Router mode Hub 4 in the same state.
      VM Mods have acknowledged this as an issue under investigation.


      Like they would know.  Got a clear example?

  • Sephiroth's avatar
    Sephiroth
    Alessandro Volta

    Sure - they've raised a ticket.  I don't think the hub is 'shot' though.  The pods/Connect App are are a party to this and, of course, it does indeed all have to work together and thus it would be reasonable to suspect the software in the Hub 4.  It won't be a hardware issue.

    My Hub 4 firmware was updated earlier this month:

    Standard specification compliant: DOCSIS 3.1
    Hardware version: 11
    Software version: 01.04.092.07.09.EURO.PC20(Open Source Information)