The current system we have in the office is 2x analogue telephone lines (2x 2wire) which connect to a panasonic 206 telephone switching system which distributes phone's to various offices. The VM h...
The VM hub ‘dongle’ excepts standard British telephone plugs or alternatively you can use an RJ11 plug on a cable into your system. Two or three wires should not matter, the third wire only goes to a capacitor in the hub to support very old style telephones, mostly not used on current phones.
Not sure about the actual wiring, but if you only have one Virgin line then only the TEL 1 port will be active. The TEL2 port is separately wired for customers renting two Virgin lines.
The maximum REN value of a hub port is 3, so make sure you don't exceed this.
I would also point out that this forum is for Residential Virgin customers. If you are a Virgin Business customer you will have different kit to what we have installed & staff on this forum are not trained to advise on it.
The info is out there but needs some interpretation and adaptation for the situation you are describing so use the following at your own risk/judgement ..
If the connection on the back of the VM Hitron hub is RJ11 then it will be the centre two pins (3,4) which are the line pair.
Look into one of the phone sockets on the back of the hub and you will (probably) see only two pins, the centre two.
The VM adapter converts those to a BT socket
The BT socket uses pins 2 and 5 for the line pair.
(note both the RJ11 and BT plugs are 6 position connectors but often some of the actual pins may be missing as they are not required so actual cables and adapters may be 6P4C or 6P2C - 6 position plug/socket with 4 or 2 conductors. This applies when counting the pin numbers as well where some of the actual pins/conductors may not be present though the slot for them is there)
The phone manual for the PBX looks as if this might be it
The internal PBX connector looks like it is IDC and requires solid core cable. Any leads you buy to make the connection may be stranded so you may need some kind of junction box between the two cable types, or make your own RJ11 to PBX cable using solid core cable.
Interesting to see how/if the Panasonic PBX works when connected to the lines from the VM hub which are not true POTS connections. The PBX seems a fairly elderly system.
Was the PBX previously connected to two separate telephone numbers (i.e. two separate lines) or was it a multi-line arrangement (two lines under the same number)?
They haven't completed the switch over with the lines yet. The existing has 2 separate lines with 2 separate numbers. If one is busy the other line gets used apparently.?!?
The bosses are tight as.... and want to keep the phone exchange, who knows if it's going to work or not. We will see tomorrow!
