[ADVICE] My advice for setting up Eero 6 with Superhub
Wasted a couple of hours trying to get this setup following the instructions. I work in IT so tried all sorts to try and get it working. Put it in Modem mode and PC gets an IP address fine but the eero won't get a connected to the network. Tried with manual IP settings (there is no DNS settings) both on 192.168.10 network and on the other IP address that my PC was getting IPv4 Address. . . . . . . . . . . : 81.108.246.218(Preferred) >> gave it 81.108.246.100 Subnet Mask . . . . . . . . . . . : 255.255.252.0 Lease Obtained. . . . . . . . . . : 26 October 2024 18:57:20 Lease Expires . . . . . . . . . . : 02 November 2024 18:22:55 Default Gateway . . . . . . . . . : fe80::2a52:61ff:fef1:b01a%2 81.108.244.1 also with no joy. I have 3 eero devices and tried with all three. Did full resets and still no joy. I think the problem is something down to DHCP after you switch to modem mode. If you keep it in router mode then it connects fine and gets the IP. What I have done is gone in and turned off the wifi signals for both so they don't interfere. I could try modem mode now they are setup but I don't want to tempt fate and get back to stage 1 I had similar issues with my superhub 3 but was hoping could get it working fine with superhub 4 with modem mode but same issues abound. To turn off the wifi signals you need to first disable the setting at the bottom and then the other options that are greyed out become active. Now all three eero devices setup and router modem with wifi turned off (I used same network name and pass to make it easy for already setup devices)