ContributionsMost RecentMost LikesSolutionsRe: Red power light on SH3 No, he didn't change the hub, it isn't too hot to touch, I can comfortably hold my hand on it and the red light remains on. Peter Re: Red power light on SH3 Hi Ashleigh, I had a visit from an excellent engineer on loan from Leicester, his name was Shabir. He carried out several tests on my SH3, removed a 6db attenuator fitted at my last visit several years ago, this was causing low signal failures. His take on the red LED was that the SH3 was fitted with two LEDs on manufacture, one red and one white, the white light has a much shorter life than the red one so if it fails, the red LED lights so he says the website is incorrect. Peter Red power light on SH3 I noticed today that the power light on my SH3 is permanently red. I followed the instructions on the website and did a pinhole reset but that made no difference. The hub feels quite warm to the touch so I called 150 and was told there is a temporary disconnection fault on my broadband and it would be monitored until 7pm tomorrow. I tried to read what it says on the website "In either Mode the red power light is an indication of over heating and most not be ignored. Ensure that the Hub is in a well ventilated area and nothing is blocking the vent holes on the sides of the Hub. If the Hub is in a clear area and is cool to touch and the red power light remains on the Hub must be replaced." well, it is well ventilated and isn't cool to the touch but the guy I spoke to didn't want to hear that, just kept rabbiting on about a temporary disconnection fault so what should I do? Solved