Forum Discussion

MHH2772's avatar
MHH2772
Tuning in
2 years ago
Solved

Wi-Fi - More than one channel?

Hello, We have a new Hub 3.0 (that's what it says on the base) and I'm experiencing occasional problems with network printing which didn't occur with the old hub. We have a very old house with thick...
  • Client62's avatar
    Client62
    2 years ago

    One assumes looking at the available Wi-Fi SSIDs with your mobile phone
    you can see both VM1234567 and VM1234567 2

    You don't mention if the Hub 3 is in Router or Modem mode - so perhaps the Hub 3 and / or the Deco units are configured with a split SSID ?

    Also check the Wi-Fi configuration on the Deco units - if present, make sure "AP Isolation" is Disabled.

    We have an Epson printer we tried with Wi-Fi but it was forever not being found so we
    connected via the 10/100 network adaptor and now it is super reliable for laptops & mobiles.

Client62's avatar
Client62
Alessandro Volta
2 years ago

One assumes looking at the available Wi-Fi SSIDs with your mobile phone
you can see both VM1234567 and VM1234567 2

You don't mention if the Hub 3 is in Router or Modem mode - so perhaps the Hub 3 and / or the Deco units are configured with a split SSID ?

Also check the Wi-Fi configuration on the Deco units - if present, make sure "AP Isolation" is Disabled.

We have an Epson printer we tried with Wi-Fi but it was forever not being found so we
connected via the 10/100 network adaptor and now it is super reliable for laptops & mobiles.