ContributionsMost RecentMost LikesSolutionsRe: Get the most from your Gig1 service and Hub 4 Nothing wrong with the Hub4 if you disable the Wi-Fi signals I get 948 Mbps no problem Like I said earlier in this topic ............ just disable 2.4G and 5G Wi-Fi on the Router The Hub4 runs smoothly with no problems , no rebooting , no freezing Re: Get the most from your Gig1 service and Hub 4 Like I said before...... just disable 2.4G and 5G Wi-Fi on the Router The Hub4 runs smoothly with no problems Re: Get the most from your Gig1 service and Hub 4 Disabled Wi-Fi 5G and 2.4G on Hub4 Then connect two EAP’s via cat7 cable POE (one upstairs one downstairs) Job done ✅ Re: Get the most from your Gig1 service and Hub 4 I have 5 Sonoff switches and 19 efamilycloud plugs All Alexa control. I have had the same nightmare problems connecting the switches but the plug is connected no problem I also have 7 x IP cameras (port forwarding setup) And have had a nightmare to set these up to the hub4 also. It is as though the Router gets overloaded giving out internal ip’s DHCP I also had to disable auto and manually set 2.4 GHz to channel 1 In the end I have had to buy an {Access Point} and plug that into the hub4 ethernet port Using the access point I created a new Wi-Fi SSID name just for my Sonoff Switches This worked. But it has been a nightmare to set up my Alexa controlled house. Changing from hub 3 to the hub 4 allotted me a new ISP WAN IP address I don’t know if this new IP address has anything to do with the problems.