Power levels look OK. A lot of Post RS errors which is not healthy, assuming that the hub has been rebooted very recently and that is not just a historical build up of errors.
Posting the network log might help, to show some correlation with the Post RS errors.
Disclaimer - I don't work for Virgin Media. I'm just another VM user trying to help out. My setup: V6 TV box, M350 Fibre broadband with Hub 3 in modem mode connected to a Netgear R7000 router. Telewest/VM user since 2001.
I'm a Very Insightful Person, I'm here to share knowledge, I don't work for Virgin Media. Learn more
Have I helped? Click Mark as Helpful Answer or use Kudos to say thanks
Safe mode (with networking) attempted - as well I can run a test from my hard wired LAN controller, same result - 85-90 down each time.
Those speeds are suspiciously like what you would get on a 10/100 device that wasn't gigabit enabled. What device are you testing on and what NIC card does the device have and are the drivers up to date? Is there a 10/100 switch in the loop somewhere?
-------------------- John --------------------
My services: HD TV on VIP (+ Sky Sports & Movies & BT sport), x3 V6 boxes (1 wired 2 WiFi,) SH2 in modem mode with Airport Extreme Router. On VIVID200, Talk Anytime Phone, x2 Mobile SIM only iPhones.
You ain't wrong. I just found a bad patch cable between my security gateway and the modem, and I'm back to where I once was - 190 or so. Still not 300, but the bad patch was skewing results from my normally truted connection.
Laptop claims a Gig connection, but I'll find another adapter and try it again, just in case...
Anyone with any ideas on the throughput differences with the Virgin Hub 3.0 in straight modem/Gateway vs. Router mode?