Here is My BQM
Channel Frequency (Hz) Power (dBmV) SNR (dB) Modulation Channel ID
Downstream bonded channels
Channel Locked Status RxMER (dB) Pre RS Errors Post RS Errors
Upstream bonded channels
Channel Frequency (Hz) Power (dBmV) Symbol Rate (ksps) Modulation Channel ID
Channel Channel Type T1 Timeouts T2 Timeouts T3 Timeouts T4 Timeouts
Primary Downstream Service Flow
Primary Upstream Service Flow
Time Priority Description
Your Pre & Post RS Error counts are quite high.
In an ideal world they would be at zero and stay there. To zero them can you reboot the Hub using this method and then keep an eye on the counts.
Switch the Hub off using the small switch on the rear of the Hub next to the power cord and pull the PSU plug from the wall socket.
Give it a good 5 minutes put the plug back in and switch the Hub back on.
Allow the Hub a few minutes to fully restart then check the counts again in an hour or so.
Thanks for taking a look at this - is there a next step that I should take now?
Thanks for the post Cocoland and sorry for the delay in response.
How are things at the moment? Is this through wired as well as WiFi?
Hello, wired is fine, it’s WiFi that has the issues.
@cocoland wrote:Hello, wired is fine, it’s WiFi that has the issues.
Used wired connections or get your self some decent gigabit enabled Wi-Fi broadcast equipment.