This new firmware is rubbish, I run 2 hub 3's in different locations, the one hub got this update way before the other and I thought issues I saw with that one and still do where related to local area or hardware fault but now I've had this new firmware a week I've noticed some changes here.
Main concern is the increase in jitter, its showing on my BQM's which suggests to me some additional resources are being used, this theory is backed by the following,
The hub interface is now very slow compared to before,
wifi is also struggling to serve bandwidth (Wasn't a problem before)
wifi also now will not use DFS channels like it did before (not that I used them unless required)
Concerns over potential intergration of Plume software (Privacy)
I've performed factory reset but as I guessed not changing anything, may I also advise that current setup is Hub 3 (router mode) Gigabit wired Desktop and 1x Wireless Device (Pixel 4a) (no other devices connected)
If I've helped let me know 🙂
10 year's managing 9 Virgin Media accounts, and things never got any better, closed last 4 accounts since January 2021 :L
Both my Hub3’s were updated via NMS on 15th Jan and no problem with obtaining 200/20 on my v10 version and also350/35 both with my 2015 iPad Pro @ 13.7 iPadOS.
However my new iPad Pro(4th gen) @ 14.3 iPadOS will only connect to my 350/35 v1* hardware version despite playing with PRIVATE ADDRESS turned on or off on 200/20 Tier connection. Since I no longer have access to trials forums I cannot publically reveal further information of my V1* VMDG505 Hub! (Even though it’s released in public domain since early 2019 )....... 😞 ......... unless @Kev_B gives me explicit written permission. 😜
Regards Tony "Life is a Binary Inspired Turing Computed Hologram"(don't PM or @Mention me - in case ignoring you offends) DEFROCKED