Hello All these Pas few Months im getting some strange speeds.
If i do random speed test i get around 30 60 mb via wifi so. when i try ethernet and i get similar this is where i got lil concerned as i. normally hit 180 plus by ethernet cable.
My 3.0 Hub is in modem mode and i been trying to figure this out so i check the wireing and tighten all connection.
yesterday i reset the router it still in modem mode and on wifi i got 200 i was very pleased.
but few hours later the connection dropped.
now im getting around 40 to 60 wired or wireless at 3pm and stayed the same.
i have reset the router and all other equipment still same
i hv SH in modem. mode then a Netgear Router plus a LinkSys Mesh Sys. still same speeds.
i hv removed the netgear router and put the mesh system as router and mesh wifi still same speeds.
Downstream bonded channels
Channel Frequency (Hz) Power (dBmV) SNR (dB) Modulation Channel ID
Upstream bonded channels
Channel Frequency (Hz) Power (dBmV) Symbol Rate (ksps) Modulation Channel ID
there should be 24 channels on the downstream and a second page - post those
you say you have reset the hub a couple of times do you switch it back to modem mode each time - if not it will be in router mode
wifi tests are meaningless only do speed test wired and try one with only the hub3 connected directly to a pc which is in safe mode with networking
i did test on wired and still get around 50mb
i reset the router via pin and did a test again and was around 80mb
All test via ethernet on a windows 7 laptop which use to get 180 190 before.
now i cant get access to modem mode stats.
Sorry to hear about the slow speeds you're experiencing.
Have you been bale to get higher speeds using the HUB 3 since you last posted?
Let us know so we can help.