WAP to WAP2

[balbi1]

Hi,

I'm trying to change to WAP2, following the below guidance: 

Step 1. Enter 192.168.0.1 into your browser

Step 2. Enter your admin name and password

Step 3. Once signed in, go to Advanced settings > Wireless> Security Select the dropdown next to Security and change it to WPA2-PSK

Step 4. Select Apply changes

 All goes well till step 3, I don't have the indicated dropdown next to Security. The options that are under Security are the following:

• Firewall
• MAC filtering
• IP and port filtering
• Port forwarding
• Port triggering
• DMZ

Any suggestions on how to proceed?

Thank you!

[goslow]

What hub are you using? What options are you seeing.

The 7th screenshot on this page is for the Hub 3 (titled 'WiFi configuration' in red text)

https://setuprouter.com/router/virgin-media/hub-3-0/screenshots.htm

and shows the section you should be looking at

Advanced settings>>Wireless>>Security then use the 'Security' dropdown on the main bit of the page to make the changes (for both 2.4GHz and 5GHz if split)

[newapollo · Accepted solution]

Hi @balbi1 

You aren't clicking the correct section for step 3

Advanced settings > Wireless> Security Select the dropdown next to Security and change it to WPA2-PSK

Intead you clicked on Advanced settings>Security

See screenshot

[balbi1]

Hi Dave,

Thank you! That's the part I was missing... Now I can proceed to tinker with options 😉