3 weeks ago
My Hub 3 has DHCP for my V6 box preset by myself to 192.168.0.16
When my V6 box powers up, it goes through "Awaiting DHCP"
Then says the address is 192.168.10.108
And therefore does not connect to the other services.....
Is this a problem with the Hub OR the V6 box ????
Did you use a Reserved DHCP IP, or did you just set a static IP?
I see no reason why any TV box should have a static IP address, so put it back to factory setting and it will get its IP address assigned dynamically.
I gave it a reserved address so that it would get a valid one instead of 192,168,10,108 , which is what the DHCP was giving it......Hub 3 is just giving out duff addresses........
Why do you think the hub is giving out wrong addresses?
All of the address's to ALL of my device's , V6 box, Laptops, Network access points ETC. Are ALL wrong......
Are you sure you set the DHCP scope to 192.168.0.xxx? If you have next move would be a full 60 second pinhole reset on the Hub. Do not reboot it, just let it do it’s own thing.
BQM, Test for outgoing ports and SSL/L2TP VPN test
@legacy1 wrote:Do you have HomePlug - Network Via Mains?
It’s either this, and you’re picking up dhcp leases from a neighbours device, or you have another device acting as a dhcp server on your network.
I had an idea...
Since I could not log into the Hub using 192.168.0.1
I tried 192.168.10.1
This brought up the login page for an access point in my garden....
Turning this OFF and rebooting the Hub sorted the problem with DHCP.
The external access point was a locating the address's. ....