OK, the switch to Fibre has happened today. After re-booting the Hub 3 we were able to dial out and receive calls, but, there is no dialing tone. We are in a Purple Zone, if that helps. The instructions said to wait for 2 minutes for dialling tone, but after an hour there is still no tone. Is this a fault, or to be expected in a Purple Zone?
This may be stating the obvious (sorry) but If your handset is a DECT (wireless) one it may not make a tone until it dials a number, most of them won't do anything until you've entered a number & pressed the call (or phone icon).
However if yours did previously before the 21CV and without you doing anything, be it a DECT or a corded handset, there may be a fault somewhere.
VM TV/Phone + EBUL v3/Mobile/Broadband via FTTP/RFoG. Hub 3.0 in modem mode with Raspberry Pi (running Openwrt) as router.
Thank you, you are correct. I have been used to phones that give a dialling tone when you pick them off the rest. Now it seems you only get a tone when one is actually dialling. All is functioning OK which is the main thing.