on 14-05-2022 22:24
on 15-05-2022 00:55
Hi @james52
You need to reset the remote.
Hold the TV and Clear buttons together until the light at the top of the V6 remote flashes green twice
Press the thumbs down button 3 times then press OK twice.
The light at the top of the V6 remote will flash green, after 10 seconds the V6 remote will revert to infra red mode.
on 15-05-2022 00:55
Hi @james52
You need to reset the remote.
Hold the TV and Clear buttons together until the light at the top of the V6 remote flashes green twice
Press the thumbs down button 3 times then press OK twice.
The light at the top of the V6 remote will flash green, after 10 seconds the V6 remote will revert to infra red mode.
on 15-05-2022 10:15
how do I switch from RF to infrared on the Virgin Media 360 Box remotes?
on 15-05-2022 15:39
Hi again @james52
Each 360 remote pairs 1 to 1 with the box, it does not use infra-red (IR). This means you can only use one remote with a box and not multiple.
on 15-05-2022 15:49
are you saying that 360 remotes do not have an IR mode; only RF? my installer has set up boxes (Media Hub 4; Virgin TV 360 primary box, two TV 360 mini boxes) in a utility room and then cable connected each box to a TV elsewhere in the house. Each box came with its own remote. He was planning to connect infrared on each remote for each specific TV i.e. each TV would thus have its own remote.
Thanks
on 17-05-2022 19:18
Apologies for this not being explained james52,
Welcome back to the community.
The 360 remotes should still be able to pair the remotes with your TV's however.
Have you completed this?
Let us know,
on 17-05-2022 19:36
Hi james52,
The 360 remote uses RF to the box and IR to any paired device, TV and soundbar.
on 18-05-2022 14:07
on 18-05-2022 15:42
Hi james52,
I suppose you would say it's automatic because it depends on the command being sent for example if you want to change the volume that would be sent IR to either your TV or Soundbar, on the 360 you have a Volume keys control setting that can be set to either device, and a change channel command would be RF as that is being sent to the 360.
Hope that makes sense.
Roy
on 18-05-2022 16:59