on 29-03-2022 23:24
Hi,
I upgraded my Internet today using the hub 4 in modem mode and using asus zenwfif xt8 as mesh (one upstairs which is main one, other is upstairs) I'm using cat 8 cables through out the house. I'm getting between 300 and 400 mbps.
Cheers
on 30-03-2022 00:53
You could downgrade if VM network for your area can't deliver.
I have doubt if you go to router mode and run "RealSpeed" that you get 1Gb to the hub
on 30-03-2022 10:30
so I just done the test and this is what I got, yet I'm not getting anywhere near those speeds
on 30-03-2022 10:37
just ran a speed test as well and this is what I got
on 30-03-2022 10:37
Can you connect an ethernet device to the primary Asus unit, and see what speed that gives? Should show if the problem is purely wifi, or something between the hub and the Asus.
on 30-03-2022 10:47
So just did this and I'm getting lower speeds than over wifi
on 30-03-2022 10:53
@Wampa wrote:<snip> so I just done the test and this is what I got, yet I'm not getting anywhere near those speeds
I thought samknows Realspeed does not work in modem mode as the OP states this is how he is running the Hub ?
I'm a Very Insightful Person, I'm here to share knowledge, I don't work for Virgin Media. Learn more
Have I helped? Click Mark as Helpful Answer or use Kudos to say thanks
on 30-03-2022 10:53
I changed it to router mode and connected one device
on 30-03-2022 11:07
Good move. Sounds like its the broadband, not the Asus.
Pull up the log in page for the hub. But don't log in, just click on the link "Check router status" That'll bring up a window with five tabs. Open the Downstream tab. Select all the text (Ctrl-A if using a keyboard), copy it (Ctrl-C), then paste it (Ctrl-V) into a reply here as TEXT not screenshots. Post that, do the same for the Upstream and Network log. You'll get an error message when you post the Network log, just click on "post" a second time.
There's a few foibles - Hub 4 sometimes doesn't report error counts properly, and if it is to do so then ideally needs to have run for 12-24 hours since changing mode or restarting. But we could take a look now for obvious problems with power or noise levels.
on 30-03-2022 11:34
1 | 39400000 | 36.770599 | 5120 KSym/sec | 64QAM | 9 |
2 | 46200000 | 36.520599 | 5120 KSym/sec | 64QAM | 8 |
3 | 53700000 | 36.770599 | 5120 KSym/sec | 64QAM | 7 |
4 | 60300000 | 37.020599 | 5120 KSym/sec | 64QAM | 6 |
1 | US_TYPE_STDMA | 0 | 0 | 0 | 0 |
2 | US_TYPE_STDMA | 0 | 0 | 0 | 0 |
3 | US_TYPE_STDMA | 0 | 0 | 1 | 0 |
4 | US_TYPE_STDMA | 0 | 0 | 0 | 0 |