Forum Discussion

Tomrich1985's avatar
Tomrich1985
Joining in
10 months ago

Google wifi setup with hub5

Good evening,  I've had the router installed today after leaving sky and I am having problems migrating my Google wifi over. I've attempted numerous times putting the router into modem mode the gre...
Tudor's avatar
Tudor
Very Insightful Person
10 months ago

You must follow a specific sequence, details below:

How to put a VM hub into modem mode:

1) Access your hub on 192.168.0.1, sign on and put it into modem mode. On the Hub3 the bottom LED will change to magenta, on a Hub4 the LED band will be green, on a Hub5 the LED will be green. Best done from a wired connection.

2) Turn off the hub and disconnect any Ethernet cables

3) Fully initialise your own router or mesh master unit and make sure the WAN port is set to DHCP (for some routers or mesh this may have to be done in router mode before entering modem mode)

4) Connect your router or mesh master unit to the VM hub with an Ethernet cable, Cat5e or Cat6, any higher specification is a waste of money. On a Hub5 use port 4.

5) Turn on the VM hub.

6) You should now be able to access the internet and the hub will now be on 192.168.100.1

Note1: this only needs doing once for each new router or when VM changes your WAN IP address.

Note2: If you have a Hub4 and your own router is NOT 192.168.0.1 then it’s possible that you can still access the VM hub on 192.168.0.1

  • Tomrich1985's avatar
    Tomrich1985
    Joining in
    10 months ago

    Thankyou for taking the time to reply. 

    I found this response on another thread and followed it exactly, do you know if when you put it into the modem mode it should give a success message? The green light comes on but on the screen the animation still spins regardless of how long left for? 

    Many thanks 

    • Sabrina_B's avatar
      Sabrina_B
      Forum Team
      10 months ago

      Hi Tomrich1985 👋.

      Thanks for reaching out to us and welcome to the Community Forums, apologies for the issues that you are having with the Hub and modem mode. Can I ask, have you been able to resolve this since your post or are you in need of further assistance?

      Please let us know. 

      Sabrina

      • Tomrich1985's avatar
        Tomrich1985
        Joining in
        10 months ago

        Hi, 

        Unfortunately not, I've tried repeating the steps above without success. 

        If I use the hub as normal (not in modem mode) it works but the speeds are extremely slow in comparison to how it should be.