Forum Discussion
What IP range is used on the LAN of your 3rd party Router ?
I have multiple, in the 172.18.0.0/16 range. All are configured to hide nat behind the interface facing the superhub. I will add there have been no internal changes, only swapped out the superhub, and I could browse to the 192.168.100.1 address of the superhub2 prior to swapout (I grabbed some status screenshots).
Thanks,
Adam.
- adamc1479 months agoJoining in
To add further as I meant to mention this in the original post: when do the status check on the vm support page, it says there is something rong with the hub and it needs to be reset (which I've done manually multiple times), the automatic reset also fails from the webpage. So I think management access is broken completely. Is it a firmware issue? I've seen others post similar issues.
- Cardiffman2829 months agoTrouble shooter
Try a 60 second pinhole reset of the hub with no ethernet connection.
- adamc1479 months agoJoining in
Thank you, done that multiple times.
Related Content
- 4 months ago
- 8 months ago
- 3 months ago