I have been unabe to connect to my work VPN since moving to Virgin media. Any ideas what is happening?
If your work uses the Cisco AnyConnect Clietn for accessing VPN then the below should hopefully resolve for you?
On the Hub 3.0 router, under Advanced Settings-->Security-->Firewall, you'll have the 4 below options.
- IPv4 firewall protection- Block fragmented IP packets- Port scan detection- IP flood detection
From the above 4 options make sure that only the "IPv4 Firewall Protection" is ticked and remove the rest.
Once you have done this power off the router for a few minutes then back on and then retry your work VPN connection.
Hope this helps!