Menu
Reply
  • 5
  • 0
  • 0
darkblue1965
Joining in
1,015 Views
Message 1 of 3
Flag for a moderator

Nordvpn router connected to VM hub 3.0

Hi I am trying to connect a Linksys wireless router running shibby Tomato firmware 1.28 to my Virgin hub 3.0.  The router will be used as a VPN with Nordvpn account installed on it.

I have tried followng instructions from this site for doing this using VM hub 2.0 but screenshots I have seen seem to differ to what I see when I go into the settings for VM hub 3.0.  

So far I have changed VM hub 3.0 to operate in Modem mode. Connected an ether net cable from a LAN port to the WAN port on the Tomato router. I have then restarted the VM hub and then Tomato router.

When I scan for wireless the VM wireless has gone and I see the Tomato router. 

I connect to the Tomato wireless successfully but there is no actual Internet access.

I assume I must change the internal settingstorage of the VM router? Any help appreciated, thanks.

0 Kudos
Reply
  • 3
  • 0
  • 0
BrianAscroft
Settling in
1,006 Views
Message 2 of 3
Flag for a moderator

Re: Nordvpn router connected to VM hub 3.0

Hi @darkblue1965,

What model of Linksys router are you using? Is it a Cisco device?
0 Kudos
Reply
  • 5
  • 0
  • 0
darkblue1965
Joining in
995 Views
Message 3 of 3
Flag for a moderator

Re: Nordvpn router connected to VM hub 3.0

The router I am using is a LINKSYS wireless WRT54GL Flashed with Shibby Tomato 1.28. 

0 Kudos
Reply